RF Coaxial 1 to 3 Way Power Splitter 400-500MHz Signal Booster Divider N Female 50ohm Divider Walkie Talkie Use

  • $26.99
    Unit price per 
Tax included. Shipping calculated at checkout.


Interphone/Relay Station Indoor Coverage Engineering N-Female Type Head One-point Three-power Splitter Power Splitter 300-500MHz

Product introduction:
The Coaxial 1 to 3 Way power splitter is called a 1 to 3 Way power divider. It is a device that divides the energy of one input signal into 3 way power outputs. It can also synthesize multiple signal energy into one output.

Specification:
Frequency range: 400-500MHz
Division Ratio: 3.01dB
Insertion Loss: ≤3.4dB
Ripple in-band: ≤±0.2dB
Isolation: ≥18dB
Amplitude Balance: ≤0.2dB
Phase Balance: ≤5°
V.S.W.R: ≤ 1.3 dB
Impedance: 50Ω/N  
Power Capacitance: 50W
Temperature: -25~+55°C
Connector: N-Female
Application: Indoor
Size: 74x61x25mm
Weight: 0.3kg
3 Way Splitter for walkie-talkie booster / repeater station or CDMA 450mhz  
walkie-talkie / interphone power splitter

Standard package:
1* Microstrip 3 Way Power Splitter

How it Work
1. Receives Signal
The powerful antenna reaches out to access a good signal, and delivers it to the booster.
2. Boostes Signal
The booster receives the signal, amplifies it, and serves as a relay between your phone and the nearest cell tower.
3. Broadcasts Signal
Your devices get increased cell reception, and calls and data are fed through the booster back to the network.

How to Install
Step 1:
Find a position where could receive great signal,mostly a higher position, like at rooftop. Install outdoor antenna at it and make it toward the base station.
Note: the outdoor antenna shall receive good signal, otherwise the repeater could not work.
Step 2:
Connect outdoor antenna to booster at BTS connector with the cable.
Step 3:
Connect indoor antenna to booster at MS connector. And it would be better to install it at a height of 2 meters.
Note: The two antennas shall be totally separated by a brick wall with a distance of at least 10 meters. Otherwise, the signal would intervene to each other, showing full of signal on display, but actually the booster doesn't work properly.
Step4:
Plug in power supply and done!


Offer Custom:
If you require a different mounting style, we will be happy to consider your requirements to provide a working solution. Please contact us.